Our LS oil pressure gauge installation kit includes all the parts needed to install a mechanical oil pressure gauge on the GM LS engine. This kit includes the M16 x 1.5 mm adaptor fitting that fits into the port located at the back of the block (LS1) or valley cover (LS2), pre-made AN4 hose assembly and two adaptors for the gauge end of the hose. This kit is ideal for engine swaps that use a mechanical oil pressure gauge.

More From This Category

Autometer Thermal Printer Roll, Test Equipment

Autometer Thermal Printer Roll, Test Equipment

$6.05

Autometer Lead & Gator Clamp Assy, Pos & Neg, Bva-260, Test Equipment

Autometer Lead & Gator Clamp Assy, Pos & Neg, Bva-260, Test Equipment

$443.97

Autometer Lap Timing Receiver, Infrared , Stack Instruments

Autometer Lap Timing Receiver, Infrared , Stack Instruments

$608.01

SAAS Oil Pressure Sender Trax Series Gauge Inc Loom

SAAS Oil Pressure Sender Trax Series Gauge Inc Loom

$60.49

SAAS Gauge Pillar Pod Falcon 2002 - 2010 Ba - Bf, Each

SAAS Gauge Pillar Pod Falcon 2002 - 2010 Ba - Bf, Each

$128.35

Autometer Driveshaft Rpm Sensor Kit, 47.6Mm / 1.875", Stack Data Acquisition

Autometer Driveshaft Rpm Sensor Kit, 47.6Mm / 1.875", Stack Data Acquisition

$392.05