P/N 554-118 is designed as a drop-in sensor replacement for flying magnet crank trigger setups using a 3/4-16" threaded magnetic sensor. This sensor is a Hall Effect sensor, meaning it outputs a square wave signal, which is ideal for use with most Electronic Fuel Injection Systems. This sensor is to only be used with a trigger wheel with "flying magnets". It does not detect a ferrous steel target.

More From This Category

Haltech Inputs and CAN Expansion Products, Air Temp Sensors, Weld Fitting - Aluminum Thread: 3/8 NPT 18TPI, Each

Haltech Inputs and CAN Expansion Products, Air Temp Sensors, Weld Fitting - Aluminum Thread: 3/8 NPT 18TPI, Each

$15.00

Haltech Outputs and Ignition Systems, Boost Control, Boost Control Solenoid 4 Port Thread: 1/8 NPT, Kit

Haltech Outputs and Ignition Systems, Boost Control, Boost Control Solenoid 4 Port Thread: 1/8 NPT, Kit

$199.00

Haltech Wiring and Connectivity, Engine and Sensor Plugs and Pins, Plug and Pins Only - Suits Bosch 145psi Fluid Pressure and Temperature Sensor, Each

Haltech Wiring and Connectivity, Engine and Sensor Plugs and Pins, Plug and Pins Only - Suits Bosch 145psi Fluid Pressure and Temperature Sensor, Each

$30.00

Haltech Inputs and CAN Expansion Products, CAN Thermocouple Expansion Products, 1/4" Open Tip Thermocouple Length: 1.07m (42"), Kit

Haltech Inputs and CAN Expansion Products, CAN Thermocouple Expansion Products, 1/4" Open Tip Thermocouple Length: 1.07m (42"), Kit

$129.00