P/N 554-118 is designed as a drop-in sensor replacement for flying magnet crank trigger setups using a 3/4-16" threaded magnetic sensor. This sensor is a Hall Effect sensor, meaning it outputs a square wave signal, which is ideal for use with most Electronic Fuel Injection Systems. This sensor is to only be used with a trigger wheel with "flying magnets". It does not detect a ferrous steel target.

More From This Category

Haltech Inputs and CAN Expansion Products, Air Temp Sensors, Weld Fitting - Aluminum Thread: 3/8 NPT 18TPI, Each

Haltech Inputs and CAN Expansion Products, Air Temp Sensors, Weld Fitting - Aluminum Thread: 3/8 NPT 18TPI, Each

$15.00

Racepak Sensors, Thermocouple Head Temp

Racepak Sensors, Thermocouple Head Temp

$352.87

Haltech Inputs and CAN Expansion, Map Sensors, 250 PSI Motorsport Fuel/Oil/Wastegate Pressure Sensor (Stainless Steel Diaphragm) Thread: 1/8 NPT, Kit

Haltech Inputs and CAN Expansion, Map Sensors, 250 PSI Motorsport Fuel/Oil/Wastegate Pressure Sensor (Stainless Steel Diaphragm) Thread: 1/8 NPT, Kit

$289.00

Racepak Accessories, Sensor Wheelie Bar Load Cell

Racepak Accessories, Sensor Wheelie Bar Load Cell

$815.77

Racepak Accessories, Gps Antenna Sma 5M

Racepak Accessories, Gps Antenna Sma 5M

$174.74

Haltech Outputs and Ignition Systems, Boost Control, Boost Control Solenoid 3 Port 33Hz Thread: 1/8 NPT, Kit

Haltech Outputs and Ignition Systems, Boost Control, Boost Control Solenoid 3 Port 33Hz Thread: 1/8 NPT, Kit

$179.00