The Reid Racing, Inc. tailshaft housings are designed to fit both the REID Superglide and the stock GM Powerglide transmissions. 5 times stronger than stock, yet weighs only 4-1/2 pounds

  • Bolt in replacement – length and crossmember mounting flange is exactly the same as stock

  • Double lip seal

  • Relocated vent puts an end to the problem of trans fluid spraying out of breather

  • Completely pre-assembled

  • Includes a hardware kit with everything you need to bolt it on

Special Note: No speedometer cable provision is supplied.

This model uses a needle rolling bearing to transfer maximum horsepower. A modified stock driveshaft yoke or special hardened undersize yoke is required (*see yokes section)

More From This Category

REID Powerglide/Superglide Tailshaft Housing With Turbo 400 Bushing, Each

REID Powerglide/Superglide Tailshaft Housing With Turbo 400 Bushing, Each

$325.78

Strange ,S60 / GM G-Body tubed / No ends or mounts

Strange ,S60 / GM G-Body tubed / No ends or mounts

$1,910.59

Strange ,Strange Ford 9" L/W alum case/LW steel spool/std gear/coupler

Strange ,Strange Ford 9" L/W alum case/LW steel spool/std gear/coupler

$3,512.90

Strange ,S60 '73-'87 C10 Housing W, Mounts & Ends

Strange ,S60 '73-'87 C10 Housing W, Mounts & Ends

$2,262.54