The pressure inside the intake manifold is an extremely important input to the ECU. This sensor will respond to changes in manifold pressures and relay the information to the ECU in the form of a voltage signal ranging from about 1 volt to 5 volts. Several different versions are available for normally-aspirated and engines with blowers. Applications up to 15 lbs. of boost.

Features:
  • For use with MSD controls.
  • Applications up to 15 lbs of boost.
  • More From This Category

    Haltech Inputs and CAN Expansion Products, Air Temp Sensors, Weld Fitting - Aluminum Thread: 3/8 NPT 18TPI, Each

    Haltech Inputs and CAN Expansion Products, Air Temp Sensors, Weld Fitting - Aluminum Thread: 3/8 NPT 18TPI, Each

    $15.00

    Haltech Outputs and Ignition Systems, Boost Control, Boost Control Solenoid 4 Port Thread: 1/8 NPT, Kit

    Haltech Outputs and Ignition Systems, Boost Control, Boost Control Solenoid 4 Port Thread: 1/8 NPT, Kit

    $199.00

    Haltech Wiring and Connectivity, Engine and Sensor Plugs and Pins, Plug and Pins Only - Suits Bosch 145psi Fluid Pressure and Temperature Sensor, Each

    Haltech Wiring and Connectivity, Engine and Sensor Plugs and Pins, Plug and Pins Only - Suits Bosch 145psi Fluid Pressure and Temperature Sensor, Each

    $30.00

    Haltech Inputs and CAN Expansion Products, CAN Thermocouple Expansion Products, 1/4" Open Tip Thermocouple Length: 1.07m (42"), Kit

    Haltech Inputs and CAN Expansion Products, CAN Thermocouple Expansion Products, 1/4" Open Tip Thermocouple Length: 1.07m (42"), Kit

    $129.00