Deeper spline has 70% additional height engagement for extra torque capacity and reduced wear
Front cover made from a high-quality AISI 1026 fully machined steel forging
6 High strength weld-on studs will not flex, pull or screw out
Thicker cross section between studs and lockup surface for a stronger cover, better support of the studs and better heat dissipation
Low surface finish on the lockup surface for consistent lockup and long clutch life
Center thrust area is ground and parallel for use of turbine hubs with bearings
Thrust face to lockup surface is the same as OE for more consistent rebuilding
Longer lip to make it easier to reuse impeller covers

More From This Category

MANLEY Valve Spring and Retainer, NexTek, Dual, 8mm Stem Diameter, 7 Degree Lock, 1.311 in. Spring O.D, Kit

MANLEY Valve Spring and Retainer, NexTek, Dual, 8mm Stem Diameter, 7 Degree Lock, 1.311 in. Spring O.D, Kit

$1,181.04

Sonnax Modulator Plug Gasket, GM, Powerglide

Sonnax Modulator Plug Gasket, GM, Powerglide

$10.92

DBA Front Street Series En-Shield Brake Rotor, 302mm, For Peugeot RCZ 1.6L 115kw Turbo 10/10-9/15, Kit

DBA Front Street Series En-Shield Brake Rotor, 302mm, For Peugeot RCZ 1.6L 115kw Turbo 10/10-9/15, Kit

$244.60

Trick Flow Port and Polishing Kit, 86-Piece, Cartridge Rolls, 60/80/120-Grit, Assorted Sizes, 1/4 in. Shank Mandrels, Kit

Trick Flow Port and Polishing Kit, 86-Piece, Cartridge Rolls, 60/80/120-Grit, Assorted Sizes, 1/4 in. Shank Mandrels, Kit

$168.20

CVF Racing Pulley Kit, 2 Groove, LWP, Big Block For Chevrolet, Kit

CVF Racing Pulley Kit, 2 Groove, LWP, Big Block For Chevrolet, Kit

$328.62