Sonnax FD-CC-17L4 is a fully machined, 4-stud version of FD-CC-17S. This forged front cover, like FD-CC-17S, Sonnax’s 6-stud version, has a deeper spline with 70% additional height engagement over OE front covers for extra torque capacity and reduced wear.
High-strength weld-on studs will not flex, pull out or screw out
Thicker cross section between studs and lockup surface for a stronger cover
Better support of the studs and better heat dissipation
Center thrust area is ground and parallel for use of turbine hubs with bearings, fiber washers or bimetals
4 Studs
Gas applications only

More From This Category

Motive Gear Ring and Pinion, 4.30 Ratio, For GM, 8.25 in., Set

Motive Gear Ring and Pinion, 4.30 Ratio, For GM, 8.25 in., Set

$471.92

Autometer Direct Fit Dash Kit, Camaro 79-81, Tach/Mph/Fuel/Oilp/Wtmp/Volt, Ultra-Lite Ii, Ultra-Lite

Autometer Direct Fit Dash Kit, Camaro 79-81, Tach/Mph/Fuel/Oilp/Wtmp/Volt, Ultra-Lite Ii, Ultra-Lite

$2,387.54 $2,513.20

5% OFF