Stock replacement crush collar/sleeve for Ford 8” rear axles. Collapsible spacer installs on the pinion and preloads the pinion bearings. Crush sleeves are not reusable.

  • This is designed to be a stock replacement crush collar/sleeve for Ford 8" rear axles
  • Collapsible spacer installs on the pinion and preloads the pinion bearings
  • Crush sleeves are not reusable and must be replaced if the pinion nut is loosened or removed
  • Inside diameter measures 1.215"
  • Overall thickness of this crush washer is .484"

More From This Category

RTS Pinion Seal, Ford, 9 in, High Speed Viton Material, Large, 35 Spline Pinion, 3.00″ OD x 2.040″ ID x .375″ wide, Each

RTS Pinion Seal, Ford, 9 in, High Speed Viton Material, Large, 35 Spline Pinion, 3.00″ OD x 2.040″ ID x .375″ wide, Each

$21.06

Motive Gear Gear Install Kit, GM 8.2, Kit

Motive Gear Gear Install Kit, GM 8.2, Kit

$531.66

Motive Gear Ring and Pinion, 4.10 Ratio, For GM, 7.5 in., Set

Motive Gear Ring and Pinion, 4.10 Ratio, For GM, 7.5 in., Set

$401.85