The timing cover and rear cover on GM LS series engines don't have any dowel pins to ensure correct alignment to the centerline of the crankshaft & this often leads to annoying leaks at the front damper seal and rear main seal. These special alignment tools from Proflow centre the front or rear cover when it is installed, and allow an easy way to install the seal by lightly tapping on the tool with rubber mallet. Choose from three styles of these alignment tools for front and rear covers. Plastic construction with O-rings.

More From This Category

Powerhouse Camshaft Installation Handle

Powerhouse Camshaft Installation Handle

$171.00

COMP Cams Valve Spring Compressor, Steel, Shaft Mount, Mopar, 383-440/B1, Each

COMP Cams Valve Spring Compressor, Steel, Shaft Mount, Mopar, 383-440/B1, Each

$320.82

Trick Flow Valve Seat, Ductile Iron, Intake, 2.087 in. Outside Diameter, For Ford, Small Block, Set of 4

Trick Flow Valve Seat, Ductile Iron, Intake, 2.087 in. Outside Diameter, For Ford, Small Block, Set of 4

$82.80

COMP Cams Pushrod, Magnum, Chromoly, Heat-Treated 9.250 in. Long, .080 in. Wall, 3/8 in. Diameter, Set of 8

COMP Cams Pushrod, Magnum, Chromoly, Heat-Treated 9.250 in. Long, .080 in. Wall, 3/8 in. Diameter, Set of 8

$167.39

COMP Cams Pushrod, Magnum, Each Length Checker 7.500 in. to 8.700 in.

COMP Cams Pushrod, Magnum, Each Length Checker 7.500 in. to 8.700 in.

$38.96

COMP Cams Push Rod, Dual Taper, Chromoly, 7.600 in. Long, .165 in. Wall, 7/16 in. Diameter, Set of 16

COMP Cams Push Rod, Dual Taper, Chromoly, 7.600 in. Long, .165 in. Wall, 7/16 in. Diameter, Set of 16

$612.27