RTS's Thread pitch on this pinion nut is 3/4"-20. Fits 8" and 9" Ford rear axles. This pinion nut is ready for install with red thread locker coating pre-applied for a complete installation on your next project.

  • Thread pitch on this pinion nut is 3/4"-20
  • Fits Ford 8 inch , 8.8 and 9 inch Ford rear ends
  • Material Type: Steel
  • 25 & 28 Spline Pinions 

More From This Category

Motive Gear Ring and Pinion, 6.00 Ratio, For Ford, 9 in., Set

Motive Gear Ring and Pinion, 6.00 Ratio, For Ford, 9 in., Set

$386.94

Strange ,Transmission Yoke, 2-Piece, Needle Bearing, 27 Spline, GM, Powerglide, TH350, T-56, 4L60, 4L60E, Muncie, T-10, Each

Strange ,Transmission Yoke, 2-Piece, Needle Bearing, 27 Spline, GM, Powerglide, TH350, T-56, 4L60, 4L60E, Muncie, T-10, Each

$564.78

Motive Gear Ring and Pinion, 4.88 Ratio, For Dana 30, 7.125 in., Set

Motive Gear Ring and Pinion, 4.88 Ratio, For Dana 30, 7.125 in., Set

$294.13

Strange ,S60 / w/ leaf spring mounts / No ends

Strange ,S60 / w/ leaf spring mounts / No ends

$2,001.09