Product Description:

The Reid Racing, Inc. tailshaft housings are designed to fit both the REID Superglide and the stock GM Powerglide transmissions. 5 times stronger than stock, yet weighs only 4-1/2 pounds

  • Bolt in replacement – length and crossmember mounting flange is exactly the same as stock

  • Double lip seal

  • Relocated vent puts an end to the problem of trans fluid spraying out of breather

  • Completely pre-assembled

  • Includes a hardware kit with everything you need to bolt it on

Special Note: No speedometer cable provision is supplied.

This model is used when the Superglide has a Turbo 400 output shaft. A standard Turbo 400 driveshaft bushing is installed and a stock Turbo 400 type yoke can be used (see yokes section).

More From This Category

Strange ,Center Section, Ultra Aluminum, 35-Spline, Spool, Billet Pinion Support, Special Order, Each

Strange ,Center Section, Ultra Aluminum, 35-Spline, Spool, Billet Pinion Support, Special Order, Each

$5,261.44

Strange ,S60 w/ ends / No mounts

Strange ,S60 w/ ends / No mounts

$1,910.59

Strange ,S60 G-Body bare casting w/ ears / no tubes / no ends

Strange ,S60 G-Body bare casting w/ ears / no tubes / no ends

$1,196.63

Strange ,12 blt F-Body casting w/ ends and F-Body mounts

Strange ,12 blt F-Body casting w/ ends and F-Body mounts

$2,789.99

Strange ,S60 / GM G-Body w/ ends / No mounts

Strange ,S60 / GM G-Body w/ ends / No mounts

$2,111.71

Strange ,S60 F-Body bare casting w/ torque arm provision

Strange ,S60 F-Body bare casting w/ torque arm provision

$1,397.75