Stainless Steel Spacer, 1in. Bore, 2-7/8in. Wide, High Misalignment (PART #QA1-SG16-1212)

QA1

high misalignment spacers

are made from high quality stainless steel in a variety of sizes. Spacers are used in applications when mounting brackets are wider than the rod end ball width. High misalignment spacers, which reduce the rod end bore size so that an increased angle or higher misalignment is achieved, are typically used when more articulation is needed.

High Misalignment Standard Ball Width SG Series spacers will fit WPB-T (size 14 & 16 only), AIB, SIB and MIB spherical bearings and all inch rod ends.

BODY:

Stainless Steel

SPECIFICATIONS

Bore ID 1in.

More From This Category

QA1 Rod End, AF Series Endura, Aluminium/Steel, Right Hand, 0.1875in. Bore, 3/16 Thread, Stud Red, Each

QA1 Rod End, AF Series Endura, Aluminium/Steel, Right Hand, 0.1875in. Bore, 3/16 Thread, Stud Red, Each

$14.39

QA1 Rod End, MCF Series, 2-Pieces, Carbon/Steel, Left Hand, 8mm-8mm, Each

QA1 Rod End, MCF Series, 2-Pieces, Carbon/Steel, Left Hand, 8mm-8mm, Each

$8.75

QA1 Jam Nut, Steel, Natural, 1-1/4-12 LH, 1-7/8in. Hex, 11/16in. Width, Each

QA1 Jam Nut, Steel, Natural, 1-1/4-12 LH, 1-7/8in. Hex, 11/16in. Width, Each

$12.29

QA1 Rod End, CM Series, 2-Pieces, Carbon/Steel, Right Hand, 1/8-1/8, Each

QA1 Rod End, CM Series, 2-Pieces, Carbon/Steel, Right Hand, 1/8-1/8, Each

$8.57

QA1 Rod End, GF Series, 2-Pieces, 303 SS Right Hand, 12mm-12mm, Teflon , Each

QA1 Rod End, GF Series, 2-Pieces, 303 SS Right Hand, 12mm-12mm, Teflon , Each

$68.78