These two new MAP sensor adapters from Holley EFI allow you to quickly add a stainless steel MAP sensor to your existing installation. Holley part #558-466 adapts harnesses with a (MPFI) Weatherpack 3-pin connector to the 3-pin Delphi GT connector, commonly found on aftermarket stainless steel MAP sensors, such as the Holley 5-BAR MAP sensor, part #554-108. Holley part # 558-467 adapts harnesses with a Delphi M/P 150 3-pin connector, commonly found on LS engine harnesses, to the 3-pin Delphi GT connector

Features:
  • Genuine OEM (original equipment manufacturer) Connectors
  • Techflex F6 loomed harness provides protection from engine bay dirt and grime, while matching your Holley EFI harness for a clean installation
  • Plug and play pre-termination allows you to quickly convert any installation to an aftermarket MAP sensor
  • More From This Category

    Classic Instruments Gauge, Air Pressure, Full Sweep 2 5/8" Diameter, Grey, Matte-Black

    Classic Instruments Gauge, Air Pressure, Full Sweep 2 5/8" Diameter, Grey, Matte-Black

    $517.22

    Racepak Accessories, Weldment Nut & Ferrule 1/4

    Racepak Accessories, Weldment Nut & Ferrule 1/4

    $24.63

    MSD Ignition Coil, Smart Coil, Coil Pack, Epoxy, Female/Socket, Red, Square, Each

    MSD Ignition Coil, Smart Coil, Coil Pack, Epoxy, Female/Socket, Red, Square, Each

    $264.53