Clevite H-Series rod bearings were developed primarily for use in NASCAR type racing but are suitable for all types of competition engines. These H-Series bearings have a medium level of eccentricity, high crush factor, and have hardened steel backs and thin overlays. They also have enlarged chamfers for greater crankshaft fillet clearance and are made without flash plating for better seating. Bearings with .001 in. extra clearance are available for standard size shafts and with or without dowel holes. H-Series bearings are recommended for use with crankshafts that have oversize fillets and where engines run in the medium to high rpm range. They should also be used if contact patterns obtained with Clevite P-Series bearings are too narrow. Contact patterns should ideally cover 2/3 to 3/4 of the bearing surface.

More From This Category

ICON Piston, 4 in. Bore, 1.5mm, 1.5mm, 3.0mm Ring Grooves, For Chevrolet 350 Rod 6.000 Flat Top +4.7cc 2V, .030 Oversized, w/ Rings, Each

ICON Piston, 4 in. Bore, 1.5mm, 1.5mm, 3.0mm Ring Grooves, For Chevrolet 350 Rod 6.000 Flat Top +4.7cc 2V, .030 Oversized, w/ Rings, Each

$1,709.08

MANLEY Piston, Coated, Extreme Duty, 1.115 in. Compression Distance, 4.130 in. Bore Size, -20cc Dish, Coated, For Chevrolet SB, Each

MANLEY Piston, Coated, Extreme Duty, 1.115 in. Compression Distance, 4.130 in. Bore Size, -20cc Dish, Coated, For Chevrolet SB, Each

$298.95

Wilwood PAD,D1185-30,AXLE SET,12 PADS

Wilwood PAD,D1185-30,AXLE SET,12 PADS

$475.33

MILODON Gear Drive, Single Idler, 0.250 in. Raised Cam, Injection/Blown Drive, Mopar, Big Block B/RB/Hemi, Set

MILODON Gear Drive, Single Idler, 0.250 in. Raised Cam, Injection/Blown Drive, Mopar, Big Block B/RB/Hemi, Set

$2,680.54

QA1 26 Series Shock, Monotube, 7in. Stroke, 3C/12MR, Linear, Hyperscrew

QA1 26 Series Shock, Monotube, 7in. Stroke, 3C/12MR, Linear, Hyperscrew

$427.67