Remove pressed-in rocker studs and tap for screw-in studs with these rocker stud puller and tap guides from COMP Cams. To remove pressed-in rocker studs, slide the rocker stud puller over two side-by-side studs, and then crank down on the retaining nut to force out the stud. Use the tool with the included tap guide to ensure proper alignment when tapping the stud boss for screw-in studs.

More From This Category

COMP Cams Camshaft Degree Kit, Heads Off, For Chevrolet Small Block LS-Series, Kit

COMP Cams Camshaft Degree Kit, Heads Off, For Chevrolet Small Block LS-Series, Kit

$436.55

COMP Cams Push Rod, Dual Taper, Chromoly, 8.600 in. Long, .165 in. Wall, 7/16 in. Diameter, Set of 16

COMP Cams Push Rod, Dual Taper, Chromoly, 8.600 in. Long, .165 in. Wall, 7/16 in. Diameter, Set of 16

$619.76

COMP Cams Pushrod, Magnum, Chromoly, Heat-Treated 8.492 in. Long, .080 in. Wall, 3/8 in. Diameter, Each

COMP Cams Pushrod, Magnum, Chromoly, Heat-Treated 8.492 in. Long, .080 in. Wall, 3/8 in. Diameter, Each

$23.86

Trick Flow Valve Seat, Ductile Iron, Exhaust, 1.657 in. Outside Diameter, For Chevrolet, Small Block, 23 Degree Heads, Each

Trick Flow Valve Seat, Ductile Iron, Exhaust, 1.657 in. Outside Diameter, For Chevrolet, Small Block, 23 Degree Heads, Each

$29.87

COMP Cams Pushrod, Hi-Tech, Chromoly, Heat-Treated, 10.050 in. Long, .080 in. Wall, 3/8 in. Diameter, Each

COMP Cams Pushrod, Hi-Tech, Chromoly, Heat-Treated, 10.050 in. Long, .080 in. Wall, 3/8 in. Diameter, Each

$31.19