Includes: Terminated engine Harness. Firewall grommet, moulded 6 power circuit Haltech fuse box and lid. 5 relays, 5 fuses and pins for the spare power circuit.

Notes: This harness can also support 1JZ-GTE engines but will require either a 2JZ coolant temperature sensor or a connector changed to (P/N AMP 184004).


OVERVIEW

The fastest and most cost effective way to wire your race car or engine conversion!Simply connect a handful of labelled wires and this plug and Play product allows you to be up and running in just a few hours.
  • An efficient Haltech Plug'n'Play product that allows you to be up and running in just a few hours.
  • The quick start guide will walk you through installation of the Haltech Plug'n'Play harness into your vehicle.
  • The guide is accompanied by the full ECU manual and Software located on the CD or USB key provided with the ECU to refer to while completing your installation and configuration.

FEATURES

  • This harness when installed in conjunction with a Haltech Elite ECU opens the door to virtually limitless performance modification and tuning of your vehicle.
  • Fully programmable systems allow you to extract all the performance from your engine by delivering precisely the required amount of fuel and ignition timing that your engine requires for maximum output under all operating conditions. 

More From This Category

Rostra Transmission 4L60/65/70-E Internal Wire Harness Connector Seal; 17-Way, 4L60-E Holden Commodore, 4L65-E, 4L70-E, GM, 2009-2012

Rostra Transmission 4L60/65/70-E Internal Wire Harness Connector Seal; 17-Way, 4L60-E Holden Commodore, 4L65-E, 4L70-E, GM, 2009-2012

$16.37

Rostra Transmission VW 09G/TF60/61SN late production Wire Harness W/6-Pin Conn. For Input/Output Sensors w/ Temp Sensor, Aisin Warner, Audi, Mini, Sea

Rostra Transmission VW 09G/TF60/61SN late production Wire Harness W/6-Pin Conn. For Input/Output Sensors w/ Temp Sensor, Aisin Warner, Audi, Mini, Sea

$165.10

Haltech Elite ECUs, Elite 2500 GM GEN III LS1 & LS6 (DBW Retrofit Ready) Terminated Harness Injector Connector: Bosch EV1 (as per factory), Kit

Haltech Elite ECUs, Elite 2500 GM GEN III LS1 & LS6 (DBW Retrofit Ready) Terminated Harness Injector Connector: Bosch EV1 (as per factory), Kit

$960.00

MSD Wiring Harness, Replacement, 6AL2, Each

MSD Wiring Harness, Replacement, 6AL2, Each

$92.98