Haltech Reverse / Back-up Camera Kit (PART #HT-060400)

Suits: uC-10 Display Dash

Includes: Camera - CVBS, 720 x 480, 170 degree viewing angle, IP67 Licence plate mounting bracket 6m (19') Camera wire harness Double-sided mounting tape and screws

Everything you require to add a reverse / back-up camera to your vehicle. Compatiable with Haltech uC-10 display dash for use with the camera input function. Requires uC-10 firmware version v2.29.x or later.

Camera - CVBS, 720 x 480, 170 degree viewing angle, IP67 with fitted grommet and optional guide lines.

Simple installation with the pre terminated 6m (19') and labeled shielded harness

Mounting options included

  • Licence plate mounting bracket
  • Double sided tape with screws

More From This Category

Autometer Wire Harness, Mfd/Mfr Gps Interface, Stack Instruments

Autometer Wire Harness, Mfd/Mfr Gps Interface, Stack Instruments

$92.01

Racepak Accessories, Cable A Side Lsu Amp

Racepak Accessories, Cable A Side Lsu Amp

$479.90

Autometer Network Harness, Dvl To Stack Dash Display / Logging System, Stack Data Acquisition

Autometer Network Harness, Dvl To Stack Dash Display / Logging System, Stack Data Acquisition

$486.96

Haltech Engine and Sensor Plugs and Pins, Plug and Pins Only - Bosch EV1 (Square) 2 Pin Junior Timer Female Connector, Each

Haltech Engine and Sensor Plugs and Pins, Plug and Pins Only - Bosch EV1 (Square) 2 Pin Junior Timer Female Connector, Each

$21.00

Haltech ECU + Plug'n'Play Kits, Elite 2500 Adaptor Harness Kits, Elite 2500 + Subaru Liberty/Legacy Gen 4 3.0R & GT Plug 'n' Play Adaptor Harness Kit

Haltech ECU + Plug'n'Play Kits, Elite 2500 Adaptor Harness Kits, Elite 2500 + Subaru Liberty/Legacy Gen 4 3.0R & GT Plug 'n' Play Adaptor Harness Kit

$3,510.00