These RTS LS1/LS6 Chev & Holden motor mount kits allow you to put that "little bit different" engine in your project. They have urethane bushings and include both the engine and frame brackets. Frame brackets must be cut to fit and welded to frame. 

Specs

  • 4-bolt engine flange measures 6-5/8" x 4-1/2" with one corner angled off
  • Bolt holes are 4-3/8" horizontal and 3-1/4" vertical with the vertical holes slotted for adjustment
  • Frame mount is 6-1/2" from center of bushing sleeve to end of weld on tab
  • Lower weld on tab extends an additional 1-1/4" further than the top tab
  • Bushing outside diameter is 1-1/2" and bushing length is 2-7/8"

More From This Category

Motive Gear Carrier Shim Kit, Dana 44 JK, Dana 44 JK Reverse, Dana 44 Standard, For Toyota 9.0 Reverse, Kit

Motive Gear Carrier Shim Kit, Dana 44 JK, Dana 44 JK Reverse, Dana 44 Standard, For Toyota 9.0 Reverse, Kit

$36.54

Motive Gear Ring and Pinion, 4.11 Ratio, For GM8.25F/GM8.5R, 8.25/8.5 in., Kit

Motive Gear Ring and Pinion, 4.11 Ratio, For GM8.25F/GM8.5R, 8.25/8.5 in., Kit

$1,160.28

MILODON Main Caps, Ductile Iron, 5-Cap Set, Straight, 2-Bolt, For Chrysler, For Dodge, For Plymouth, 426-440, Set

MILODON Main Caps, Ductile Iron, 5-Cap Set, Straight, 2-Bolt, For Chrysler, For Dodge, For Plymouth, 426-440, Set

$1,438.88

Strange ,Strange Lower Control Arm Tube Kit w/ 7, 16 in. Rod Ends

Strange ,Strange Lower Control Arm Tube Kit w/ 7, 16 in. Rod Ends

$433.91

Motive Gear Ring and Pinion, 4.10 Ratio, For Chrysler, 10.5 in., Set

Motive Gear Ring and Pinion, 4.10 Ratio, For Chrysler, 10.5 in., Set

$690.82