12V Electric Water Pump (EWP) Relay Wiring Kit (PART #8520)

This kit will allow you to wire up your Electric Water Pump (EWP) for continuous running, connect to an on/off switch, or thermal switch.

*Note: This kit is included in our EWP Kit retail packs.

**Note: If you want to run our Digital Controller, please look at our EWP Combo packs or our Digital Controller-only pack Part #8002.

KIT CONTENTS

PART DESCRIPTION UNITS
EWP Basic Wiring Harness 1
RED - Wire Joiner 1
RED - 6mm Ring Terminal 1
RELAY - 12V 40 Amp 5 Pin W/- Resistor Protection 1
SCREW - SELF TAP 8X3/8 BZ 1

More From This Category

MILODON Transmission Dipstick, Braided Stainless Steel, Natural, C-6, Each

MILODON Transmission Dipstick, Braided Stainless Steel, Natural, C-6, Each

$268.97

SPEED PRO Pistons, Each Forged, Dome, 4.310 in. Bore, BB For Chevrolet 454ci Dome, Each (Minimum Order Qty 8)

SPEED PRO Pistons, Each Forged, Dome, 4.310 in. Bore, BB For Chevrolet 454ci Dome, Each (Minimum Order Qty 8)

$159.68

MANLEY Pushrod, Swedged End, 4130 Chromoly, 7/16 in. Dia, 8.280 in. Length, .165 in. Wall, Each

MANLEY Pushrod, Swedged End, 4130 Chromoly, 7/16 in. Dia, 8.280 in. Length, .165 in. Wall, Each

$42.49

MILODON Engine Studs, Steel, Black Oxide, 7/16 in.-14 Base, 7/16 in.-20 Top, 3.750 in. Length, Set of 4

MILODON Engine Studs, Steel, Black Oxide, 7/16 in.-14 Base, 7/16 in.-20 Top, 3.750 in. Length, Set of 4

$80.18